Just noticed that after creating a toolpath and then showing the simulation I can't switch of the green toolpath to just see the simulation.
Anybody having the same issue ?
Richard
MeshCAM 7 Build 4
Simulation issue
1 post
• Page 1 of 1
Simulation issue
by ArchieF » Wed May 03, 2017 6:14 pm
AMD Athlon II X2 215 Processor 2.7 GHz
4 GB RAM
Don't waste water - dilute it !
4 GB RAM
Don't waste water - dilute it !
- ArchieF
- Posts: 201
- Joined: Wed May 14, 2008 5:03 am
- Location: Germany, Rehau
1 post
• Page 1 of 1