MeshCAM V7 Build 25 Windows 7 64bit - ISSUE TOOL PATH

General MeshCAM Questions

MeshCAM V7 Build 25 Windows 7 64bit - ISSUE TOOL PATH

Postby larynx » Mon Jul 23, 2018 6:07 pm

Simple ply flat cut - 3 holes and a "pocket ring"

Calculated tool path is all over the map - not following contours of outer ring - lots of rapid moves, holes are ok. Checked file - everything is SMOOTH so the outer ring cut should be "bit down, go around, down, go around, ......."

Have set "depth first" so should not be rapiding all over and recutting.

File, output file and screen images attached so can be repeated.

Tried - can't upload STL, TXT, so give up.
I am not aligned with nor do I have any relationship with MeshCAM or its staff other than being a user [that sounds a little like I have a dependency problem]
larynx
 
Posts: 87
Joined: Thu Oct 29, 2015 2:56 am
Location: East Central Florida

Return to General

cron