How do I mill a perimeter circle?

General MeshCAM Questions

How do I mill a perimeter circle?

Postby huntleybill » Thu Oct 05, 2017 4:42 am

I have an image I am milling into a piece of wood stock. The stock is 3/8" thick. I would like to cut out this image from the square stock as a circle. Like a medallion that is 5.5 inches. I would like to mill out that perimeter the full 3/8" depth of the stock. I just can't figure out how to make that happen. The default stock is square and when I run that, it comes out nice. How do I make it nice but in a circle and not a square?

I am a newbe so details matter.
Thank you for your time
Bill
huntleybill
 
Posts: 5
Joined: Wed Jun 14, 2017 3:40 am

Return to General

cron