Page 1 of 1

How to mill out a circle in Meshcam

PostPosted: Thu Oct 05, 2017 2:24 am
by huntleybill
I am trying to mill an image that is going on a piece of wood that is 1/4" thick x 5.5". I would like to have the perimeter of the piece milled out in a circle. Right now it mills it in a square. I have it set to mill entire stock. The stock is 1/4" thick so I want to cut out the circle 1/4 deep". The "stock" is always square so how do I make it mill a circle, 1/16" increments? I tried to upload the file but I get an error that the .mcf is not allowed!

I hope this makes sense
Your help is appreciated.
Thank you
Bill