Meshcam problem? Half moons?

General MeshCAM Questions

Meshcam problem? Half moons?

Postby Nickf » Sat Jul 29, 2017 6:12 am

Hi every one
I Am hoping some one can help me. I have recently run in to a problem with the machining some parts and i have traced it back to a possible problem with Meshcam.
The g-code has phantom section where the machine will stop and lower a fraction and then return to its proper path a leave a small ring where the cuter was. This can happen hundreds of times in a job. it makes the finish very bad in the job and long machine times.

Have anyone ever seen this before? or have a solution?

Please see attached pic. they appear as half moon shapes in the machined surface.

Thanks alot!!!

imagejpeg_2-1.jpg (91.23 KiB) Viewed 543 times
Posts: 1
Joined: Sat Jul 29, 2017 6:08 am

Return to General