Vertical contour is dead, doesn't follow the part shape too

General MeshCAM Questions

Vertical contour is dead, doesn't follow the part shape too

Postby gunguy » Wed May 03, 2017 1:56 am

For some reason I can't post screen shots of this problem, but here goes. Vertical contour appears to be a no-go. It doesn't follow the geometry, and instead of cutting a quarter circle, it goes straight out, then 45 degrees down, then straight down then it curves a little on the bottom. It also doesn't follow geometry of the rest of the part, often shrinking the part that it cuts every depth it cuts. It hasn't done this before, now it can't be fixed. 3D roughing is enabled, so is arc fitting, and the problem remains. When disabled, there's no difference. It's as if it's gone full retard and can't be fixed. Do I need to uninstall/reinstall? If so, how do I do it?
gunguy
 
Posts: 1
Joined: Wed May 03, 2017 1:39 am

Return to General

cron