MeshCAM Beta 4 new interesting issues - stock size

Discussions relating to MeshCAM development

MeshCAM Beta 4 new interesting issues - stock size

Postby larynx » Sat May 13, 2017 7:03 pm

Funny thing happened today and I have no explanation for it - but here it is.

1. opened, loaded file and noticed that in "inches" my stock was only 0.030" in Z, when I new this was for 0.75" ply.
2. so I changed the 0.030" to 0.75" manually and the display looked nuts.
3. so I selected "fit to stock" and the same thing - 0.030" Z appeared, along with incorrect X & Y which I just noticed
4. so I switch to "mm" and got the correct inches.
5. then to inches and got incorrect stock.
6. back to mm and got the correct inches

7. so I thought - apply and see what happens so I APPLIED "mm" not inches
8. reopened define stock and had proper dimensions, but the selection was "mm" not inches....and note the XYZ lines - way below stock ? Uh.....

I am have run this file in MeshCAM 5 and it loads fine. But I decided to try Beta 4 because in 5 the "machine region" dxf is giving me fits so I decided to try it in Beta 4

screen shots UNALTERED after selections - but I expect no one to believe me, cause I don't believe me either......... is this April 1st?
mm suposedly.jpg
mm suposedly.jpg (90.34 KiB) Viewed 2090 times
inches supposedly.jpg
inches supposedly.jpg (96.42 KiB) Viewed 2090 times
after apply.jpg
after apply.jpg (39.84 KiB) Viewed 2090 times
I am not aligned with nor do I have any relationship with MeshCAM or its staff other than being a user [that sounds a little like I have a dependency problem]
Posts: 90
Joined: Thu Oct 29, 2015 2:56 am
Location: East Central Florida

Return to Development