Where to find ?

Discussions relating to MeshCAM development

Where to find ?

Postby ArchieF » Sun Jan 17, 2016 7:44 pm

Following this thread : viewtopic.php?f=11&t=15598

I see this instruction :

Click Tools, click Carbide Auto Toolpath, change material to Wood-Hard, change end-mill to #101, change Finish Quality to Higher, ensure Review toolpath settings is not checked, click OK to start calculating a toolpath

Tried to replicate the whole thing but can't find it.

So where to find
Carbide Auto Toolpath
change material


AMD Athlon II X2 215 Processor 2.7 GHz


Don't waste water - dilute it !
Posts: 201
Joined: Wed May 14, 2008 5:03 am
Location: Germany, Rehau

Re: Where to find ?

Postby Randy » Sun Jan 17, 2016 8:03 pm

Richard, that menu/wizard comes with the Carbide3D license for MeshCAM (bundled with the Nomad883 milling machine). It also locks you to the Carbide3D postprocessor, which is also tailored to the machine.

All opinions in this post are mine alone. I am not a MeshCAM employee, I do not have a financial interest in MeshCAM, nor do I speak for MeshCAM. MeshCAM user since Beta 5 in 2003. viewtopic.php?f=11&t=15333 :ugeek:
Posts: 1812
Joined: Wed May 14, 2008 9:50 am
Location: North Texas, USA

Return to Development