Rob -PLEASE - sending you a note but posting here too

Discussions relating to MeshCAM development

Rob -PLEASE - sending you a note but posting here too

Postby larynx » Tue Oct 03, 2017 3:28 pm

As I have stated elsewhere, I just set every bit to 260ipm, 50ipm plunge, but change step/depth to what I used before that worked. Then I manually lower the feed/speed to begin and increase if all goes well to a comfort level. Again, that works just too well for me, so I do not know if I change or not to a sheet. I would still need to keep track of step/depth for each op - rough/finish/end/ball..........

The best answer to me would be for Rob to just allow me to pick the bit from the table and provide IN THE 3d CUT menu a way to change it for step/depth for EACH operation right on the page, by overiding defaults without having to redefine a bit each time

Rob Please.jpg
Rob Please.jpg (142.37 KiB) Viewed 749 times
I am not aligned with nor do I have any relationship with MeshCAM or its staff other than being a user [that sounds a little like I have a dependency problem]
Posts: 70
Joined: Thu Oct 29, 2015 2:56 am
Location: East Central Florida

Return to Development