Page 1 of 1

Parameters in CutViewer?

PostPosted: Tue Apr 16, 2013 6:38 am
by jrh_engineer
Hi, I was trying out some hand edited g-code and, as far as I can tell, CutViewer doesn't handle parameters (or at least, doesn't handle parameters that have the syntax that Mach3 uses).

Now, I'm a newbie and I'd love to be told where I'm going wrong, but the code appears to load fine into Mach3.

My code is attached.

Cheers, John

Re: Parameters in CutViewer?

PostPosted: Tue Apr 16, 2013 7:21 am
by jrh_engineer
...I think I've solved my problem. It appears that I need to tell CutViewer to open the file as a Fanuc rater than standard NC file.